Paused Maytag Neptune Wont Start Again
Not Operating or Won't Start - Has Power - Elevation Load Washer
Possible Solutions
Electronic Bear on Pad Information
When using the impact control, impact the name to operate, not the lights.
Is the control locked (command on the dorsum console)?
If the Control Lock feature is activated, the Control Lock lite will be on. The controls will non answer to whatsoever touch commands.
CLICK HERE for more data on the Control panel performance if your Control panel is at the back, behind the hat.
Is the chapeau locked?
The chapeau must be completely closed and latched for the washer to operate.
Depending on your model, some washers may fill without the lid locking, and others will not even start until the lid locks. Bank check your Owner's Transmission for information on your specific model.
CLICK Hither for more than data on the lid locking
If you would like to download or view product literature for your appliance, please visit our Manuals and Literature page.
Are you pressing and property the Start button?
You may need to press and concur the starting time button for up to 3 seconds to engage the wheel.
Is the lid completely latched?
The lid must be completely closed and latched for the washer to operate.
CLICK HERE for more information regarding the lid locking
Did y'all receive an "LF" or "F8E1" Error Code?
If F8 E1 or LF (too long to make full) appears in the brandish, the washer is taking too long to fill, or the washer is filling and draining.
The drain hose may extend more than than iv.v" (114 mm) into the standpipe. Check the plumbing for the correct bleed hose installation. Use drain hose form and adhere securely to drainpipe or tub. Do not tape over the drain opening. Whatsoever of these bleed hose bug tin crusade the washer to siphon (fills and drains at the aforementioned fourth dimension), and the washer never fills to the expected level.
Either the F8E1 or the LF error codes may betoken there is some problem with the water supply going to the washer. Please brand certain both inlet hoses are connected, and both hot and common cold water supplies are turned on. This washer has sensors that detect the water supply and requires both hoses to have water going to the water valve. If it does not recognize both water supply hoses are turned on, the control detects a problem with the water pressure sensor. The chapeau will lock, and the auto will enter a pump out mode for 8 minutes.
CLICK Hither for more than information on proper installation of the drain hose
Is your washer filling correctly?
CLICK Hither for more information on the inlet hoses
Are you using anti-flood devices and controls?
Whirlpool recommends that appliances be directly connected to the h2o supply for optimum machine functioning.
CLICK HERE for more data on using flood safe devices
The F8E1 Fault code too may indicate there is some problem with the water supply going to the washer. Please make sure that both inlet hoses are connected, and both hot and cold water supplies are turned on.
CLICK Here for more information on "LF" and "F8E1" Error codes
Interested in purchasing an Extended Service Plan?
Please click below to learn more on how you can save upwards to 25% on New Appliance Extended Service Plans within 30 days of your appliance purchase.
Usa
Canada
Interested in purchasing an Extended Service Program?
Please click beneath to larn more on how you can save upward to 25% on New Apparatus Extended Service Plans within 30 days of your appliance purchase.
United States
Canada
Source: https://producthelp.maytag.com/Laundry/Washers/Top_Load_HE_Washers_(Electronic_Control)/Not_Operating/Not_Operating_or_Won't_Start_-_Has_Power_-_Top_Load_Washer
0 Response to "Paused Maytag Neptune Wont Start Again"
Post a Comment